Cornell University Library site
Libraries and Hours Ask a Librarian

Makerspace

Closed - Full Hours /

Pricing

The Makerspace is temporarily closed until further notice. We are providing virtual services (such as consultations, instruction, etc.) in the interim.

We are exploring options to offer some contact-less services (such as 3D printing) in a safe manner.

PLA Filament only

  • $2 flat fee. First hour of printing is free. $1 per hour of printing after the first hour.

PLA Filament with PVA Supports

  • $2 flat fee. First hour of printing is free. $2 per hour of printing after the first hour.
  • 1/8″ (3mm) Birch plywood – 12″ x 12″ : $3 per sheet
  • 1/8″ (3mm) Birch plywood – 12″ x 24″ : $6 per sheet
  • 1/4″ (6mm) Birch plywood – 12″ x 12″ : $4 per sheet
  • 1/4″ (6mm) Birch plywood – 12″ x 24″ : $8 per sheet
Note: Prices may vary depending on the cost of sourcing materials from our suppliers.
 
 
Scrap materials in the makerspace are free to use. Patrons can also bring their own materials for use at no charge. However, materials not sourced withing the makerspace must be verified by staff to ensure they are safe to use. If a material is unsafe to use or its authenticity cannot be verified, we will decline the use of it on those occasions.

Pricing is per linear foot

  • Tracing paper – $10
  • Polyester Fabric – $15
  • Adhesive Vinyl – $16
  • Fine Arts paper, natural – $17
  • Matte Canvas – $20
  • $0.10 per button; 2″ and 1″ buttons are available
 

If you would like to set up vouchers for your class or organization please email makerspace@cornell.edu for details.